(UTC)
  MindFusion Forums › Diagramming Components › Feature Suggestions › Tablenode - Height & Width property
(Moderator: Slavcho)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Tablenode - Height & Width property (Read 3108 times)
BidMaestro
Junior Member
**
Offline


to learn is to live

Posts: 74
Location: Australia
Joined: Apr 20th, 2008
Tablenode - Height & Width property
May 20th, 2009 at 1:56pm
Print Post  
It would be useful if the Tablenode had a height & width property that could be read to determine the tablenode dimensions. Additionally altering the values in these properties would readily alter the dimension of the tablenode. Obviously the same ability on shapenodes could also be useful
  
Back to top
WWW  
IP Logged
 
Stoyo
God Member
*****
Offline


MindFusion support

Posts: 13230
Joined: Jul 20th, 2005
Re: Tablenode - Height & Width property
Reply #1 - May 28th, 2009 at 6:44am
Print Post  
Hi Doug,

Currently this can be done by checking table.Bounds.Width and table.Bounds.Height. Setting new width and height can be done through the Resize method or by setting Bounds.

I hope that helps,
Stoyan
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

MindFusion Forums » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge